Step 1
Air Management
Choose the valves and controls that raise, lower and level your suspension.
Shop Air Management Kits
SMC 1/2-Inch Air Suspension Valve
High-flow 12-volt SMC valve for custom air suspension systems using 1/2-inch NPT plumbing. This valve is commonly used in individual-valve air management setups where fast fill and dump performance is needed.
Specifications
- Port size: 1/2-inch NPT
- Orifice size: 15 mm
- CV factor: 5.5
- Voltage: 12 volts
- Current draw: approximately 0.5 amp
- Maximum burst pressure: 300 PSI
- SMC part number: VXD240HZ1DBXB
System planning
- 4 valves: front and rear control
- 8 valves: front, rear and side-to-side control
Use fittings and air line sized for your system pressure and desired flow rate.
Build the complete system
What Else Do I Need?
Most air-suspension builds need more than one component. Use these categories to complete the system, then contact us if you want help matching parts.
Step 2
Air Bags & Mounts
Match bag size, travel, port size and available chassis clearance.
Shop Air Bags & Bag Mounts
Step 3
Compressors
Build dependable air supply around the tank size and pressure your system needs.
Shop Viair Compressors - Free Shipping
Step 4
Air Tanks
Select tank capacity and port layout for the space available in your build.
Shop Air Tanks
Step 5
Fittings
Finish the plumbing with the correct thread and air-line sizes.
Shop Fittings
Step 6
Air Line
Route the system with the line diameter required by your valves and fittings.
Shop Air Line